Honda Civic OBD1 ECU with 3 pin DLC to OBD2 16 pin (ARDUINO)

留檔備份一下

ARDUINO 應用
Honda Civic OBD1 ECU with 3 pin DLC
轉換成 OBD2 16 pin 的 標準診斷接頭
http://sourceforge.net/projects/honobdapt/?source=navbar

Description

This software and hardware system adapts your 92-95 Honda diagnostic port to an OBD II standard port, readable by any generic scan tool.

In 1996 the federal government along with the state of California mandated that all cars be equipped with comprehensive emissions reduction equipment and a standardized emissions diagnostic system. Before this year, each independent vehicle manufacturer had its own proprietary, undocumented diagnostic interface.

These interfaces provide essential information for troubleshooting a computer-controlled electronic fuel injected engine. Thus, the impetus for bringing even an older car like the 5th generation (92-95) Honda in compliance.

7 thoughts on “Honda Civic OBD1 ECU with 3 pin DLC to OBD2 16 pin (ARDUINO)

    1. 做了喔
      可是手機的APP一直沒辦法跟EL327藍牙連線
      查不到是哪邊的問題
      所以暫時放棄

  1. 版主您好,https://github.com/kerpz/ArduinoHondaOBD
    這個版本您有試過嗎? 小弟水平不到做不出來><

    1. 這個好喔!
      不過看起來要弄得到LCD才可以
      有機會再看看料能不能弄到
      需要研究研究

      1. 版主搞定 務必通知小弟
        小弟不求lcd 只要它能轉譯成Torque Pro 可讀訊號
        *\*\*\ 版主加油!! /*/*/*

發佈留言

發佈留言必須填寫的電子郵件地址不會公開。 必填欄位標示為 *

請輸入下列驗證碼計算後阿拉伯數字 (Translate it, if not Taiwanese to post reply) *